Our speaker cables are made of 12 20-gauge strands of our 99.99% pure maximum density silver, individually placed in oversized teflon sleeves and hand-woven into a flat litz braid. These strands total to 10 gauge of the best AC conductor silver on the planet.

Our conductors are set in several layers of polyurethane foam with a dielectric constant of 1.08 totaling half an inch in diameter. We set three electrically separate layers of shielding in and around this dielectric. The outer shield consists of three shields that are hand-soldered together and run from connector to connector. The result is the best electrical and mechanical shielding we can put in a cable and exceptional AC noise rejection. While these cables are certainly nice enough to deserve cable lifters, we don’t use them because the cables are so well shielded and damped that we find no additional benefit from lifting them.

The sheer mass of silver in our speaker cables makes them somewhat less pliable than the rest of our cables, but they are still much softer and easier to manipulate than one would expect from inch thick speaker cables. The bend radius is still only a few inches. Like the rest of our cables, all of our connectors are set in place with strong epoxy and will never break under anything close to normal use. And all cables that come back to the factory visually in-tact have a lifetime warranty.

Standard pricing is as follows:

$54,000 for an eight foot set

$60,000 for a ten foot set

$66,000 for a 12 foot set

Jumpers: $6,000 (highly recommended as no jumpers on the market can keep up with our cables.

Length and color are nearly infinitely customizable at no additional cost.