Direct Line Source Cables

Our USB cores are made of four strands of 22 gauge 99.99% pure monocrystalized monocore silver, which are individually housed in oversized teflon to eliminate strand and dielectric interactions. The Data +/- and 5V/ground pairs are twisted and individually shielded.
Our conductors are set in several layers of polyurethane foam with a dielectric constant of 1.08 totaling 3/8” in diameter. In addition to the inner twisted pair shields, there is an inner passive shield along with the active outer shield made of three shields hand-soldered together.
The combination of monocore silver and polyurethane foam creates a soft, pliable cable with an almost nonexistent bend radius. The cable flows in the hand. The conductor and the dielectric both stretch to a significant degree, making the solder joint the only potential failure point. Which is why we set the solder joints in epoxy, which has no discernable effect on the sound and makes the cable virtually indestructible, giving you peace of mind that you’ll never have to use the lifetime warranty the cable comes with.
Standard pricing is as follows:
$8,000 for a 4.5 foot cable
$10,000 for a six foot cable
$12,000 for an eight foot cable
Length and color are nearly infinitely customizable.

Coaxial

The cores of our interconnects are made of 17 gauge 99.99% pure molecular-forged high density silver wire with a custom Litz geometry. The strands are individually housed in oversized teflon sleeves so the primary dielectric touching the conductor wire is air and no strand interactions can occur.
Our conductors are set in several layers of polyurethane foam with a dielectric constant of 1.08. Embedded in the dielectric is a shield which is only attached to the terminal connector, which accompanies the main .82 inch shield that is attached to both connectors. This essentially convinces the core wire that the shield is always pulling forward, and causes the soundstage to edge toward you in a hauntingly beautiful way. Our interconnects measure at 100 ohms forward and 60 ohms backward.
The combination of monocore silver and polyurethane foam creates a soft, pliable cable with an almost nonexistent bend radius. The cable flows in the hand. Solder joints are stress tested for durability and all sleeving is epoxied to the connector housing, meaning any pull force goes through the connector body and not the solder joint. And if the cable still somehow fails, any cable that’s visually intact has a lifetime warranty.
Standard pricing is as follows:
$6,000 for a 4.5 foot cable
$6,600 for a six foot cable
$7,200 for an eight foot cable
$8,000 for a ten foot cable
$10,000 for a 12 foot cable
Length and color are nearly infinitely customizable.